Connect with Blackmagic Design ATEM

Setup Movie

Preparation

  • Prepare a PC for setting.
  • Install “FlexTally Utility” on the setting PC. Click here for installation instructions.
  • Please update the firmware of the FlexTally Station Unit to the latest version. See here for how to update.
  • Install “ATEM Software Control” and “ATEM Setup” on the PC for setting.
  • Make sure the Lamp Unit is fully charged.
  • Connect the Station Unit and the Lamp Unit. Click here for how to connect.
  • Set DIP switch No. 1 on the Station Unit to ON and set the connection method to “Ethernet” setting.

Setup Steps

  1. Set the DIP switches of each Lamp Unit for the channels to be used (please refer here for details).
  2. Connect the Station Unit, ATEM switcher and the setup PC to the same network.
  3. Connect the AC adapter to the Station Unit and turn it on. When the power turns on, the status LED lights up blue.
  4. Check the ATEM IP address from “ATEM Setup”.
  5. Start FlexTally Utility and select “Scan”.
  6. When the Station Unit is found, the IP address of the Station Unit will be displayed. Click on the IP address.
  7. Select “Switcher Setting”.
  8. Select “ATEM”.
  9. Enter the ATEM IP address shown at step 4 at “Switcher IP Address”.  Click “Save”.
  10. Press and hold the power button on the Lamp Unit. When the power turns on, the status LED lights up blue.
  11. Switch channels on your ATEM switcher by using the “ATEM Software Control” and make sure each lamp responds.

Note

  • Since the “Test Lamps” option in “FlexTally Utility” is affected by the ATEM connection, please test when ATEM is not connected.