Connect with Blackmagic Design ATEM

Preparation

• Please install “FlexTally Utility“.
• Please install “ATEM Software Control” and “ATEM Setup”.
• Make sure the Lamps are fully charged.
• Connect the Station and Lamps. Connection methods are here.
• Turn ON the No.1 DIP switch on the Station and change the connection method to Ethernet.
  

Setup Steps

1. Set the DIP switches of each lamp for the channels to be used (please refer here for details).
2. Connect the Station, ATEM and setup PC to the same LAN.
3. Connect the AC adapter to the Station and turn it on. When the power turns on, the status LED lights up blue.
   
4. Check the ATEM IP address from “ATEM Setup”.
   
5. Select “Search for Station Units” on “FlexTally Utility”.
   
6. When the station is found, the IP address of the Station will be displayed, click on the IP address.
   
7. Select “Switcher (ETH mode)”.
   
8. Select “Blackmagic Design ATEM Series”.
   
9. Enter the ATEM IP address and click the OK button.
   
10. Press and hold the power button on the Lamp. When the power turns on, the status LED lights up blue.
    
11. Switch ATEM channels from “ATEM Software Control” and check that each Lamp reacts.

Note

• Since the “Test Lamps” option in “FlexTally Utility” is affected by the ATEM connection, please test when ATEM is not connected.